The disorder-induced D band (at approximately 1,350 cm-1) was LY333531 ic50 not seen in the first-order Raman spectra. The intensity ratio of D band (I D) to G band (I G) can be used as an indication of defect quantity: a low I D /I G corresponds to a small

defect quantity. The absent D band in the Raman spectra shows that the deposited https://www.selleckchem.com/products/entrectinib-rxdx-101.html graphene in our samples has high quality. The sharp 2D peak in graphene is roughly three times (the largest intensity ratio of I 2D/I G = 2.8) more intense than the G peak, suggesting that the quality of the deposited graphene is comparable to that of graphene grown on foils [24]. The main growth mechanism of graphene on SiO2 with a good quality may be attributed to carbon atoms from pyrolysis of CH4 in the self-assembly adsorption process. Sun et al. [25] reported that carbon atoms readily arrange themselves in aromatic rings and planar sp 2-hybridized graphitic layers forming AZD5363 mw nanographene on a high-temperature substrate. The second mechanism is the promotion of oxygen. Since the reactive chamber has a low ultimate vacuum pressure (about 10-2 Pa) in our experiment, the remaining oxygen in the tube and the high substrate temperature will promote

adsorption of carbon atoms onto the quartz slide. Chen et al. [26] found that the presence of oxygen can enhance the capture of CH x fragments through C-O and H-O binding and thus provides more opportunities for C-C coupling and graphene nucleation. Moreover, during deposition of graphene films on SiO2, we placed

some nanoscaled Ni powder on the Si substrates in the tube to measure the electrical junction properties of graphene/Si. A few Ni nanoparticles on the Si substrates were carried on the quartz surface by CH4 and Ar gases, which accelerated the carbon atoms adhering and growing on the quartz, similar to that of graphene grown on Cu but not to graphene grown on check details Ni which occurs by a C segregation or precipitation process [21]. Figure 3 The Raman spectra of the graphene films. A 2D band peak at 2,692 cm-1 and a G band peak at 1,580 cm-1 are shown. The intensity ratio of the 5 min sample is I D/I G = 2.8. The visible light transmission rate of the graphene samples is shown in Figure 4a. The optical transparency value of the graphene film deposited for 1 min was very high, over 90%. However, it decreases with growth time because the film becomes thicker. On the other hand, the transparency of the 5 min sample still keeps on increasing, over 85% in the visible wavelength range of 400 to 800 nm, especially for 550 nm. Moreover, the transparency increases with wavelength. For long-wavelength light, such as in the 600- to 800-nm range, the graphene films are almost transparent. A high transmission rate is very useful for making solar cells because light in the 400- to 800-nm range has higher power. Figure 4b shows the transmission rate of the graphene samples in 1,000 to 3,000 nm near-infrared wavelength range.